|
Multi envelopes
As digital technology progressed, the multi-segment envelope appeared. This let you specify both time and volume levels for each stage of the
envelope and as most processing was done in cheap software rather more expensive hardware, it was easy to dial up six, eight or more segments
according to your desire for complexity.
One feature of multi-segments envelopes is that they allow you to create a contour that rises, falls and then rises again in volume.

Envelopes and amplifiers
Whatever shape the envelope might be, you won't hear any sound at all until it's fed to an amplifier. In a synthesiser, the envelope controls
the amplifier so the greater the envelope's amplitude during any phase, the more the amplifier opens and the louder the output will
be.
Modular machinations
Although envelopes are primarily used to shape the volume of a sound, in a modular synthesizer you can connect it to other modules, too.
Let's assume we're using the archetypal ADSR envelope. Let's see what happens if you apply it to the cutoff
control of a low pass filter.
|
Tech terms
Inverter
An inverter simply inverts the output signal of a device. Some envelope generators have an inverted output option which produces
an inverted envelope shape. These are generally connected to a filter or oscillator rather than an amplifier.
Gate
When a key is pressed and held down, a Gate signal is generated. When applied to an envelope generator, a Gate On message starts
the generator which will move through the Attack and Decay phases, staying at the Sustain level until a Gate Off message is
produced when the key is released which causes the envelope generator to go into the Release phase.
Transient
This can have several meanings. In recording it often means a peak or spike in the recorded signal. In synthesis it means a very
short Attack time.
|
If the cutoff in a low pass filter is closed, all the sound will be filtered out so we start with no sound at all. When the envelope
opens the cutoff shoots up creating a bright sound. Then it closes slightly dulling the sound during the Decay phase and it stays at that level
until the Release period when the sound gets less bright and finally fades altogether.
We usually don't want an envelope to control the harmonics of a sound in such a severe way so filters usually have a control to determine how
much of the modulating signal is used. This is a very useful feature because it's common for the harmonics of an acoustic instrument to
change as its volume changes. Brass instruments, for example, generally become brighter as they are played louder.
You can also plug an envelope generator into an oscillator. If you look at the ADSR illustration, you can probably work out what sort of pitch
changes the envelope is likely to make. As with filters, an Amount control will reduce the effect from a mad siren to a blip. It can be used to
add a slight pitch lift that occurs at the start of many notes in wind and brass instruments, particularly in jazz.
With our Quick Guide series on Oscillators, EQ and Filters and now volume
shaping with envelopes, we have covered the essentials of the three basic synthesis building blocks. Putting them all together is the art of the
game.

|